Setting up your AX3000 Ultra is straightforward. 1) Connect your modem to the WAN port (blue port) on your Jeton router via an Ethernet cable. 2) Power on both devices. 3) Connectyour computer/smartphone to the default SSID listed on the product sticker underneath the router (typically “Jeton_XXXX”). 4) Open your browser and navigate to http://router.jeton.tech or 192.168.10.1. 5) Follow the Jeton Setup Wizard to configure your network name (SSID), password, and internet connection type.
Key Takeaways
- To change the admin password on a TP-Link router, log in to the web management page at tplinkwifi.net or 192.168.0.1, then go to Advanced > System > Administration.
- You can also change the password through the Tether app by going to More > System > Manage Password (or Tools > System > Login Account).
- You must know the current password to set a new one.
- If you have forgotten your current password, you will need to either use Password Recovery via TP-Link ID or perform a factory reset to regain access.
- The admin login password is separate from your Wi-Fi network password.
Before You Begin
You will need one of the following: a computer with a web browser, or a smartphone or tablet with the Tether app or tpMiFi app installed from the Google Play Store or App Store. Make sure your TP-Link device is powered on and has fully rebooted before you start. To identify your device type, type your model number into the search box on the TP-Link website. The product category shown in the results will tell you which section below to follow.